Shandong BTP-M280 Uživatelský manuál

USER’S MANUAL ETHERNET INTERFACE MODULE(EIM) JK-E01 Shandong New Beiyang Information Technology Co., Ltd.

JK-E01 User’s Manual ¾ Set network parameters as IP Address Select the device in list box of main window, and click the button “IP Address Setting” t

JK-E01 User’s Manual - 8 - lected device. If same click the button “Select File” to Check if IP Address is same with that of seenter “open” window (sh

JK-E01 User’s Manual - 9 - 5.3 IPrinter driver should be installed according to the instruction of the driver in printer user’s manual and selects ser

JK-E01 User’s Manual - 10 - ¾ TCP/IP Port is installed, first click “Add Port….” button as below: Select the property column of “Ports” (shown as 5.

JK-E01 User’s Manual ¾ Click “Next ” Button (shown as figure 5.3.4) Figure 5.3.4 Add TCP/IP Printer Port ¾ Fill with “printer name or IP Address” i

JK-E01 User’s Manual - 12 - ext” Button. ¾ Default the content (figure 5.3.6) and click “N Figure 5.3.6 Add TCP/IP Print Port ¾ To end

JK-E01 User’s Manual - 13 - nd TCP/IP Port configuration is finished (shown as figure 5.3.8). ¾ Select new TCP/IP Port and click “Apply”, then “OK”,

JK-E01 User’s Manual - 14 - Run hen Status Monitor Window comes out (shown as figure 5.5.1): The usage of status monitor routine is referred to below

JK-E01 User’s Manual 5.6 HTTP functions - 15 - JK-E01 module can offer HTTP service that it uses the browser at the host to show the printer status an

JK-E01 User’s Manual - 16 - Cli nter configuring interface page. This page shall provide two configuration modes: 1. Select “Dynamic IP Address (DHCP)

JK-E01 User’s Manual Declaration Information in this document is subject to change without notice. Shandong New Beiyang Information Technology Co., Lt

JK-E01 User’s Manual 6 Interface Signal 6.1 Parameter of Network Interface Socket It meets with 10BASE-T Standard of IEEE802.3 Figure Socket of JK-E0

JK-E01 User’s Manual - 2 - 1 Overview ...

JK-E01 User’s Manual - 1 - 1 Overview 1.1 Product Description JK-E01 EIM operates with SNBC printer to implement Ethernet communication functions, suc

JK-E01 User’s Manual - 2 - arameters 2 Technical pItems Parameter Power Source Use the power offered by host printing processes, average current is

JK-E01 User’s Manual 3 Structure - 3 - 3.1 Appearance and parts Fig.3.1.1 Top View of JK-E01 EIM 1----Control board 2----Inter

JK-E01 User’s Manual - 4 - of JK-E01 module When opening packages, check if parts are short or damaged according to the Packing List. In case of short

JK-E01 User’s Manual 5 Usage of JK-E01 Module - 5 - st Page 5.1 Print Self-teAfter JK-E01 module is installed, refer to printer user’s manual to print

JK-E01 User’s Manual - 6 - ctly. The det and module configuration is referred to the description documents as bePC and interface module can be connect